If you’re considering getting a metal roof for your home, you might be wondering how do you install it. While you may not be an expert at roof installation, you’ll need to be prepared to take a few precautions. Among the most important are safety measures such as workman gloves and a sturdy ladder. You’ll also need a place to park your vehicle and a dumpster if you plan on doing the job yourself. You’ll also need a power source for your tools, which is usually available at various outlets. Some companies even provide generators. If you can’t afford to hire a professional, you can use the equity in your home to finance the project. roofing supply
Before you begin installing your metal roof, you’ll need to measure your roof’s peak to eave distance. Then, lay your first sheet of metal on top, making sure that it overlaps the edge by at least 3/4 inches. You’ll need to make sure that it’s square with the edge of the previous panel, and use neoprene washer head screws to secure it to the sheathing. Make sure to space screws equally so that they’ll be secure and prevent leaks.
You should measure the length of your roof to get an accurate estimate. Using yardsticks, a measuring tape, a chalk and line system, or even a laser leveler, you can determine how long your roof needs to be. If you’re replacing an existing roof, make sure that the metal panels you purchase match the color of the house. You can find panels in standard sizes at home improvement stores. If you’re unsure of your exact measurements, check the weather conditions before installing your roof.
Next, you should install a drip edge around the perimeter of the roof. Apply a sealant tape to the edge. Then, place the metal roofing panel over the drip edge. Make sure that the metal roofing panels overlap each other by an inch or two. Then, overlap them again. When finished, the edges should be square with the roof line. You’ll be glad you did! If you need more information, contact a professional roofer.
After installing your metal roof, you’ll need to install its eave flashing. This is a steel metal strip that covers the eave of your roof. The metal panel overhang is approximately one-quarter inch, and can be extended depending on the aesthetics of your home. The seams must be square to the edge of the metal panel. If the seams are not square, you’ll need to install eave flashing.
Before you start installing your metal roof, be sure to read the manufacturer’s instructions. For example, if you’re installing a metal roof on a shed, you should buy corresponding edging pieces, ridge cap, and screws. Then, you should consider the function of your shed and buy the appropriate hardware for the job. If you plan to use the shed as a cooking area, you’ll need to purchase an underlayment and a different type of roof deck.
