If you have ever been under the roof of a house and wondered how to apply roofing felt, you are not alone. There are thousands of homeowners who are also concerned with the process of installing roofing felt. However, while it may seem difficult, it is not impossible. With a little knowledge, you can complete the task in a matter of minutes. Read on to learn more about this process. Listed below are some of the important steps to follow when applying roofing felt. roofing
Start by placing a roll of roofing felt at the lower edge of the roof. Make sure to align the felt with the rake and the direction of the full roof. Next, roll out the strip at least halfway across the roof. Make sure the felt is wrinkle-free, and then nail it in place with roofing nails. Repeat the process for the second course of roofing felt. Make sure to leave enough room around the edges of the first course.
Now, you are ready to apply the roof felt. Lay the first row of roofing felt over the eaves by six inches. You need to ensure that you haven’t wrinkled or bubbled the felt. The next layer of roofing felt should overlap the first row by three inches, or four centimeters. When installing the roofing felt, remember to overlap the two rows perfectly, and cut any extra roofing felt with a utility knife.
After you have purchased the roofing felt, you need to measure the surface area of your roof. Each square of felt equals 100 square feet, so you should purchase extra rolls. Make sure to measure the square footage of your roof and divide this by 144. Using this method, you can get the exact square footage of your roof. You should also take the time to mark a vertical line on the roof so you can get an accurate measurement.
Once you’ve completed this step, you need to nail the felt to the roof. Make sure to use a felt adhesive so that the felt sticks to the roof without sticking to the timber. You can also use a clout nail to secure the overlapping sheet. It’s also advisable to use a level surface for laying the felt. And remember to apply a good coating of adhesive to the roof before the next step.
Besides applying the roofing felt, you also need to prepare the deck surface. It needs to be able to withstand the moisture. If you have a pre-existing roof, you will have to remove old roofing felt and any projections and adhesives. You will also have to make sure that the deck surface is completely dry. Once the deck is dry, you can then start layering the roofing felt on it. Make sure that you check the wood surfaces for decay and replace them if necessary.
The next step in the installation process is to attach the drip-edge flashing to the top surface of the felt. After you have attached the drip edge, you can begin laying the second layer of roofing felt. Ensure that you overlap the second layer of felt at least four inches. Then, use a staple gun to secure the top and bottom edges of the felt to the decking. You can repeat this process as many times as you like.
